Disassembly

Carefully remove rearview camera body part with knife

Remove screws from lower hull

Beware of tenon on lower hull and remove upper hull carefully

Unplug these 3 connectors

To separate upper and lower hull completely

Lighting

Remove rear light wire from original control board

add a 150 ohm resistor in series,  connect to CN10 on TK35. now the rare light can be controlled by AUX power control function on TK35

Replace original red LED head light with F003, connect to CN9-1

Turret rotation motor

Cut original wires, connect turret rotate motor to CN9-4

Battery and Switch

Remove original battery box, use 3mm white plastic bean to make two slots for battery cover,

Connect 2-P connector cable to switch; also trim battery cover as shown below to have more space for battery pack.

Track Motor

Replace the motor connector, than connect to CN6 and CN7

Turret disassembly

Remove screws pointed by red arrow to remove turret motor and gear ring, than you can remove turret from upper hull

Remove screws pointed by red arrow to open turret upper and lower hull

Gun elevation

cut off original wire, add 20~37 ohm 1/4 w resistor in series to reduce elevation speed, then connect motor to CN9-4 on TK35.

IR transmitter

IR transmitter is located in gun barrel, cut the wire( red and white ), and connect to CN2-2 with 1.27mm 2p connector cable.

IR receiver

Connect IR receiver to CN2-1, orange wire to HBU/TBU-, gray wire to HBU/TBU SIG, red wire to HBU/TBU+

Recoil Unit

Connect recoil motor( pointed by red arrow) to CN9-3, red wire to RECOIL MOTOR+, green wire to RECOIL MOTOR - on CN9-3, bewared that recoil motor must tunes clock wisely after modification, or recoil movement will not be smooth and recoil motor will be damaged.

Connect recoil switch (green arrow) to CN3 with 1.27mm 2p connector cable.

Speaker

Connect to CN5 with 1.27mm 2P connector cable.

In Action